【#文档大全网# 导语】以下是®文档大全网的小编为您整理的《dell-ps4100恢复出厂设置》,欢迎阅读!
dell ps4100恢复出厂设置串口命令
1、用串口线(RS232,9针)连接dell ps4100的活动控制器与pc的串口,打开超级终端(9600,8,无,1,无),用户名grpadmin,口令grpadmin登录,如果登录不了,执行步骤2:
2、拔出备控制器,重启主控制器,等待超级终端输出Press Ctrl/p to enter setup mode------,按下Ctrl+p
3、步骤2操作完成后进入恢复模式,执行下列命令:
CFE>setenv RESETPASSWORD 1
CFE>reload
注意如下输出,如果没有以下输出,说明不成功,需重新操作
WARNING:Password recovery mode... Temporarily resetting grpadmin password.
4、以用户名grpadmin,口令grpadmin登录,执行reset(此操作将丢失所有数据,慎用),按提示输入:DeleteAllMyDataNow回车
5、步骤4是对存储执行恢复模式,会丢失所有的数据,如果只是忘记了管理IP,可以执行以下来重设:
CLI>setup
出现如下配置界面:
It appears that setup was run previously,but it did not complete.Restarting setup.
Enter the network configuration for the array.
Member name []:Membername1
Network interface [rth0]
IP address for network interface []:192.168.0.49
Netmask [255.255.255.0]:255.255.255.0
Default gateway [192.168.0.1]
Initializing interface eth0. This may take a minute.....
Enter the IP address and name of the group that the array will jion.
Group name []:Groupname1
Group IP address []:192.168.0.50
Searching to see if the group exists.This may take a few minutes.